Todays Project - What did you do today?

[Mayhem]

(11-06-2016, 02:47 AM)Pete O Wrote:

(11-02-2016, 06:35 PM)PixMan Wrote: What's the depth of the slot? A calculation of the depth of the slot x 2, added to the O.D. of whatever arbor you may have will tell you what diameter saw to find.

Darren if you need a slitting saw for the job let me know, I got a mound of them amongst the horizontal mill cutters I bought. Come to think of it, I could finish the part for you on the RT if you didn't mind it looking like a kindergarten project.

Thanks for the offer Pete. I am going to make the part a little thicker and then counterbore the section to the bottom of the 'arms'. The slitting saws that I have are about 1-2mm on the short side, so a counterbore will allow me to cut all the way through.