06-20-2012, 03:09 PM
Be careful how you set it up to lift so that the force exerted on the eye/t-nut is mostly perpendicular to the table. I'm worried that if one were to use this method it would put torsion on the t-nuts causing them to gouge the t-slots or even worse.
![[Image: lifttable.gif]](http://www.arcaneiron.com/machines/lifttable.gif)
Maybe I'm being a bit too careful but give it some consideration.
-Ron
Maybe I'm being a bit too careful but give it some consideration.
-Ron
11" South Bend lathe - Wells-Index 860C mill - 16" Queen City Shaper