06-20-2012, 01:12 PM
I justused an interference press fit.
No JB weld needed, with enough of a press even the aluminum will hold the socket tighter than one could apply enough torque to move it. (Unless one applied a cheater bar long enough, but then you'd be in danger of tipping over the mill
)
Oh, btw, I did turn the OD of the socket to a non-tapered OD.
No JB weld needed, with enough of a press even the aluminum will hold the socket tighter than one could apply enough torque to move it. (Unless one applied a cheater bar long enough, but then you'd be in danger of tipping over the mill
)Oh, btw, I did turn the OD of the socket to a non-tapered OD.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.