Cleaning scrap for melting
#4
Not wanting to run a boiler, more looking at something I can just suspend things in and forget about them, pull them out and hose them off when I want them- much like rust removal with molasses as mentioned. I have just acquired a couple of empty 44-gallon drums, thinking I can use one of those to hang the cases in if I can find a suitable cleaning solution.
Would that work with the Simple Green? I have not seen it here but haven't looked either. Any clue as to what the active ingredient is?
Lathe (n); a machine tool used in the production of milling machine components.

Milling Machine (n); a machine tool used in the production of lathe components.
Reply
Thanks given by:


Messages In This Thread
Cleaning scrap for melting - by Pete O - 10-27-2016, 08:49 PM
RE: Cleaning scrap for melting - by oldskoolron - 10-27-2016, 09:48 PM
RE: Cleaning scrap for melting - by Dr Stan - 10-27-2016, 10:59 PM
RE: Cleaning scrap for melting - by Pete O - 10-28-2016, 12:32 AM
RE: Cleaning scrap for melting - by Pete O - 10-28-2016, 12:57 AM
RE: Cleaning scrap for melting - by Pete O - 10-28-2016, 06:24 AM
RE: Cleaning scrap for melting - by Dr Stan - 10-28-2016, 07:25 PM
RE: Cleaning scrap for melting - by f350ca - 10-28-2016, 10:53 AM
RE: Cleaning scrap for melting - by EdK - 10-28-2016, 05:46 PM
RE: Cleaning scrap for melting - by Vinny - 10-28-2016, 06:02 PM
RE: Cleaning scrap for melting - by Vinny - 10-28-2016, 07:35 PM
RE: Cleaning scrap for melting - by Pete O - 10-28-2016, 07:48 PM
RE: Cleaning scrap for melting - by Dr Stan - 10-28-2016, 11:34 PM
RE: Cleaning scrap for melting - by dallen - 10-28-2016, 08:50 PM
RE: Cleaning scrap for melting - by Pete O - 10-29-2016, 12:26 AM
RE: Cleaning scrap for melting - by Mayhem - 10-29-2016, 01:25 AM
RE: Cleaning scrap for melting - by dallen - 10-29-2016, 10:15 PM
RE: Cleaning scrap for melting - by Clifford B. - 10-30-2016, 02:30 PM
RE: Cleaning scrap for melting - by texx - 10-30-2016, 06:32 PM
RE: Cleaning scrap for melting - by NormanV - 01-15-2017, 02:00 PM



Users browsing this thread: 6 Guest(s)