|
First casting
|
|
on oil your furnace should look like the one in this video when running. look at the exhaust port you can only see about 3 inches or flame above the exhaust hole.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough! 
Thanks given by: Pete O
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
First casting - by Pete O - 10-20-2016, 06:34 AM
RE: First casting - by Dr Stan - 10-20-2016, 12:11 PM
RE: First casting - by Roadracer_Al - 10-20-2016, 12:39 PM
RE: First casting - by Pete O - 10-20-2016, 04:44 PM
RE: First casting - by dallen - 10-20-2016, 05:32 PM
RE: First casting - by Pete O - 10-20-2016, 09:02 PM
RE: First casting - by Pete O - 10-20-2016, 10:57 PM
RE: First casting - by Dr Stan - 10-20-2016, 11:39 PM
RE: First casting - by Mayhem - 10-21-2016, 06:56 AM
RE: First casting - by dallen - 10-21-2016, 01:54 PM
RE: First casting - by Pete O - 10-21-2016, 06:32 PM
RE: First casting - by dallen - 10-21-2016, 06:55 PM
RE: First casting - by Pete O - 10-21-2016, 10:04 PM
RE: First casting - by awemawson - 10-22-2016, 01:53 AM
RE: First casting - by Dr Stan - 10-22-2016, 12:14 PM
RE: First casting - by EdK - 10-22-2016, 12:56 PM
RE: First casting - by dallen - 10-22-2016, 02:50 PM
RE: First casting - by oldskoolron - 10-24-2016, 07:51 PM
RE: First casting - by Pete O - 10-25-2016, 01:08 AM
RE: First casting - by oldskoolron - 10-25-2016, 01:38 AM
RE: First casting - by NormanV - 10-25-2016, 10:27 AM
RE: First casting - by oldskoolron - 10-25-2016, 04:01 PM
RE: First casting - by Pete O - 10-28-2016, 06:50 AM
RE: First casting - by Mayhem - 10-28-2016, 10:38 AM
RE: First casting - by dallen - 10-28-2016, 02:23 PM
RE: First casting - by Dr Stan - 10-31-2016, 11:00 PM
RE: First casting - by oldskoolron - 10-30-2016, 08:00 PM
RE: First casting - by Dr Stan - 10-31-2016, 02:29 PM
|
