MetalworkingFun Forum › Machining › General Metalworking Discussion v
An Interesting YouTube Channel

Thread Modes
An Interesting YouTube Channel
schor Offline
Sophmore
***
Posts: 190
Threads: 17
Joined: Aug 2014
Location: Ajax Ontario Canada
The following 1 user Likes schor's post:
Mike E. (12-10-2016)
#15
10-15-2016, 08:09 AM
Tony knows what he is doing. I've been watching his videos for a long time.

He has a thread on one of the machining forums when he restored his surface grinder, it was a great thread and showed he knows what he is doing.
Steve S
Check out MyShopNotes on youtube.
Reply
Thanks given by:


Messages In This Thread
An Interesting YouTube Channel - by TomG - 10-08-2016, 08:36 AM
RE: An Interesting YouTube Channel - by EdK - 10-08-2016, 08:58 AM
RE: An Interesting YouTube Channel - by Highpower - 10-08-2016, 01:48 PM
RE: An Interesting YouTube Channel - by f350ca - 10-08-2016, 10:58 AM
RE: An Interesting YouTube Channel - by EdK - 10-08-2016, 03:09 PM
RE: An Interesting YouTube Channel - by Highpower - 10-09-2016, 12:24 PM
RE: An Interesting YouTube Channel - by texx - 10-08-2016, 03:24 PM
RE: An Interesting YouTube Channel - by Highpower - 10-09-2016, 12:21 PM
RE: An Interesting YouTube Channel - by Vinny - 10-10-2016, 06:13 PM
RE: An Interesting YouTube Channel - by EdK - 10-10-2016, 07:17 PM
RE: An Interesting YouTube Channel - by Vinny - 10-10-2016, 07:33 PM
RE: An Interesting YouTube Channel - by EdK - 10-12-2016, 05:57 PM
RE: An Interesting YouTube Channel - by schor - 10-15-2016, 08:09 AM
RE: An Interesting YouTube Channel - by Seanlogie - 12-04-2016, 12:14 PM
RE: An Interesting YouTube Channel - by Mike E. - 12-10-2016, 03:20 PM



Users browsing this thread: 1 Guest(s)