MetalworkingFun Forum › Machinery › Lathes v
Fact or Fiction Lathe 101

Thread Modes
Fact or Fiction Lathe 101
schor Offline
Sophmore
***
Posts: 190
Threads: 17
Joined: Aug 2014
Location: Ajax Ontario Canada
#2
10-15-2016, 08:05 AM
when turning you are more interested in surface feet per minute speeds for a particular material and the diameter which you then use to calculate the rpm required

Tom did a good video on that.



Steve S
Check out MyShopNotes on youtube.
Reply
Thanks given by:


Messages In This Thread
Fact or Fiction Lathe 101 - by pepi - 10-15-2016, 06:51 AM
RE: Fact or Fiction Lathe 101 - by schor - 10-15-2016, 08:05 AM
RE: Fact or Fiction Lathe 101 - by Dr Stan - 10-15-2016, 01:37 PM
RE: Fact or Fiction Lathe 101 - by TomG - 10-15-2016, 02:08 PM
RE: Fact or Fiction Lathe 101 - by Dr Stan - 10-15-2016, 11:27 PM
RE: Fact or Fiction Lathe 101 - by Vinny - 10-16-2016, 12:51 AM
RE: Fact or Fiction Lathe 101 - by Hopefuldave - 10-17-2016, 05:11 PM
RE: Fact or Fiction Lathe 101 - by TomG - 10-16-2016, 09:33 AM
RE: Fact or Fiction Lathe 101 - by the penguin - 10-16-2016, 04:05 PM
RE: Fact or Fiction Lathe 101 - by pepi - 10-16-2016, 10:49 PM



Users browsing this thread: 1 Guest(s)