Latest Delivery

[Dr Stan]

The controller I ordered also showed up today.

My weak area is electronics.  So before I install the motorized wheels on my fork lift and wire up the controller I sure could use some help.  There is a 3 position rocker switch which is obviously for fwd, rev, and off.  The variable pot is for speed control.  Looking at the terminal block I see four connections.  Two are neg and two are positive.

I gather the 4 connections are for power in and power out.  I'll be running the motors on 24v DC.  Does it matter which pair of connections I use for power in and out? Also what gauge of single strand wire should I use for power. The run will be fairly short, six feet at the most.

Thanks

Stan