|
Lathe Radius Attachment
|
10-13-2016, 03:57 PM
The tool is slid in and out of the swinging frame manually. One could build a fairly precise diameter cutting tool setting device. I recall seeing a horizontal boring mill cutter setting tool. Basically a V bock with a dial gauge resting on the tool tip. Something similar that indexed to the axis could be useful.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Lathe Radius Attachment - by Hawkeye - 10-08-2016, 08:55 PM
RE: Lathe Radius Attachment - by Vinny - 10-08-2016, 09:41 PM
RE: Lathe Radius Attachment - by stevec - 10-09-2016, 07:07 AM
RE: Lathe Radius Attachment - by Roadracer_Al - 10-09-2016, 11:46 AM
RE: Lathe Radius Attachment - by DaveH - 10-09-2016, 03:44 PM
RE: Lathe Radius Attachment - by krv3000 - 10-09-2016, 06:39 PM
RE: Lathe Radius Attachment - by Hawkeye - 10-09-2016, 09:15 PM
RE: Lathe Radius Attachment - by Roadracer_Al - 10-12-2016, 05:25 PM
RE: Lathe Radius Attachment - by pepi - 10-13-2016, 06:07 AM
RE: Lathe Radius Attachment - by wawoodman - 10-13-2016, 03:22 PM
RE: Lathe Radius Attachment - by Roadracer_Al - 10-13-2016, 03:57 PM
RE: Lathe Radius Attachment - by Hawkeye - 10-13-2016, 10:26 PM
|
