06-20-2012, 07:46 AM
I noticed on the fwd/N/rev handle, there is a roll pin but nothing obvious to attach it to. Then I noticed an image of this mill on the www.lathes.co.uk Kondia. In this picture, there appears to be a rod connecting this to the table stops. Now this makes sense but looks different to the stops on my mill. I'll have to rig something up, as it makes sense to have the stops kick the x-feed into neutral.
I also note a T-slot bolted to the ram (which is also missing). I assumed the bracket on the column that engages the T-slot was for a DRO, so I used it to mount my control box. What would the purpose of this T-slot have been?
I also note a T-slot bolted to the ram (which is also missing). I assumed the bracket on the column that engages the T-slot was for a DRO, so I used it to mount my control box. What would the purpose of this T-slot have been?
Hunting American dentists since 2015.