10-02-2016, 11:28 AM
(This post was last modified: 10-02-2016, 11:31 AM by Roadracer_Al.)
I was about to suggest that, Greg.
As far as cutting oil, for aluminum, use a mix of mineral spirits and light oil in about a 2:1 mix - 2 being the thinner.
For steel, lard or bacon fat works well, although you really must clean up with solvent after every use. Rancid animal fat smells REALLY bad.
As far as cutting oil, for aluminum, use a mix of mineral spirits and light oil in about a 2:1 mix - 2 being the thinner.
For steel, lard or bacon fat works well, although you really must clean up with solvent after every use. Rancid animal fat smells REALLY bad.