10-01-2016, 09:08 AM
As my new parting tool has failed to arrive, that will teach me to try to save 25% (now scheduled to arrive 10/7/16) , I got some GMM2020 inserts and used the Kyrocera parting tool (marketed by Grizzly) to finish my stainless steel spud job. It worked very good, the thin 2 mm cut, made the job easy. The cut quality was good, almost to the point, where it looked like I faced the tube after the parting operation. The cut was good enough to use and the end was pressed in and the orifice holes drilled, they were boxed up and on there was to the job.
jack