09-26-2016, 08:39 PM
If you're making a one-off, you could drill the corners with a 3mm drill, then the mill bulk of it with a long 6mm or whatever you can find. Then draw file the match between the hole and the milled surface.
|
How was this part made
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
How was this part made - by Wongster - 09-25-2016, 11:30 PM
RE: How was this part made - by Mayhem - 09-26-2016, 12:54 AM
RE: How was this part made - by Wongster - 09-26-2016, 03:55 AM
RE: How was this part made - by Mayhem - 09-26-2016, 04:10 AM
RE: How was this part made - by Dr Stan - 09-26-2016, 12:53 PM
RE: How was this part made - by dallen - 09-26-2016, 02:34 PM
RE: How was this part made - by Wongster - 09-26-2016, 02:55 PM
RE: How was this part made - by PixMan - 09-26-2016, 08:39 PM
RE: How was this part made - by Dr Stan - 09-26-2016, 10:55 PM
RE: How was this part made - by Wongster - 09-26-2016, 11:31 PM
RE: How was this part made - by Dr Stan - 09-27-2016, 10:14 AM
|
Users browsing this thread: 2 Guest(s)