|
How was this part made
|
09-26-2016, 03:55 AM
Thanks. Meaning this piece is also extruded instead of milled? The extrusion I mentioned is the profile that goes into the square hole.
Wongster
http://www.wongstersproduction.com Proud to be a member of MetalworkingFun Forum since Mar 2012. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
How was this part made - by Wongster - 09-25-2016, 11:30 PM
RE: How was this part made - by Mayhem - 09-26-2016, 12:54 AM
RE: How was this part made - by Wongster - 09-26-2016, 03:55 AM
RE: How was this part made - by Mayhem - 09-26-2016, 04:10 AM
RE: How was this part made - by Dr Stan - 09-26-2016, 12:53 PM
RE: How was this part made - by dallen - 09-26-2016, 02:34 PM
RE: How was this part made - by Wongster - 09-26-2016, 02:55 PM
RE: How was this part made - by PixMan - 09-26-2016, 08:39 PM
RE: How was this part made - by Dr Stan - 09-26-2016, 10:55 PM
RE: How was this part made - by Wongster - 09-26-2016, 11:31 PM
RE: How was this part made - by Dr Stan - 09-27-2016, 10:14 AM
|
