09-25-2016, 12:03 PM
The welder is set for 0.035 wire, it's always run 0.030. I changed the tip a few months ago and I don't use the welder all that often. When I got it, the guy was still on his first spool of flux core and it was over half full (2lb spool). Since then I went thru that and a 1 lb spool of flux.
The welder runs on 220. It's an HF, but it's the one made in Italy (Hobart's assy line as I recall).
The mill weighs 300-350 lbs. It's mall but not a mini. Pic here: http://www.metalworkingfun.com/showthrea...6#pid38856
I should take a look at the contactor, since I haven't even opened it up. I should also recheck my wire feed speed. Perhaps it is too fast. And while I'm at it, take a good look at the tip.
The welder runs on 220. It's an HF, but it's the one made in Italy (Hobart's assy line as I recall).
The mill weighs 300-350 lbs. It's mall but not a mini. Pic here: http://www.metalworkingfun.com/showthrea...6#pid38856
I should take a look at the contactor, since I haven't even opened it up. I should also recheck my wire feed speed. Perhaps it is too fast. And while I'm at it, take a good look at the tip.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique
the nobucks boutique etsy shop | the nobucks boutique