Table for my mill

[Vinny]

The problem was with the welder. Not me, the actual machine. I could hear the feed pulsating. Perhaps it's too tight but it will feed just fine when not welding. Shouldn't be a problem with the mains, it's a short feed from the panel and nothing else is on it (I also use that circuit for the plasma cutter) and nothing else was running.. The tip is new. I did notice that I had to to increase the power when I switched from flux to mig (yes, I changed the polarity). The wire is definitely stiffer than flux wire but this happened when the cable was straight. The steel was ground just before I started.

The cold welds were probably from the flux wire. I intentionally took the pic to hide the welds! To put the legs on I had to grind the welds After the grinding, the welds had full penetration. After grinding you couldn't see where it was welded.