Table for my mill

[Vinny]

Ran out of daylight so this is as far as I got today.



Hopefully that's far enough back so you can't see my crappy welds! I started using flux core 'cuze I'm doing this outside. Then I ran out of flux core, opened the side of the cabinet and there was a partial roll there so I switched them. Ran outta that one (there wasn't much) so I had to switch to mig wire and use the gas. Actually worked out pretty good but the feed started acting up near the end and was pulsating. When it was feeding steady I actually got some decent looking welds.

Maybe tomorrow I can put the center piece in for the front of the mill and the pads on for the levelers. Then paint!