|
not sure
|
09-23-2016, 08:14 AM
Are you talking millimeters or inches? If the height of the centers differs by .04mm, I'd leave them alone, because any taper would be insignificant. If they are .040" off, then that's another story. It won't make much difference on a large diameter, but small diameters will taper quite a bit.
Tom ![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png) |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
not sure - by oldskoolron - 09-23-2016, 03:00 AM
RE: not sure - by Pete O - 09-23-2016, 06:54 AM
RE: not sure - by TomG - 09-23-2016, 08:14 AM
RE: not sure - by Mayhem - 09-23-2016, 08:42 AM
RE: not sure - by oldskoolron - 09-23-2016, 06:33 PM
RE: not sure - by Pete O - 09-25-2016, 07:21 PM
RE: not sure - by oldskoolron - 09-26-2016, 09:22 PM
RE: not sure - by Dr Stan - 09-26-2016, 10:48 PM
|
