MetalworkingFun Forum › Machining › General Metalworking Discussion v
Resetting Tool Heights

Thread Modes
Resetting Tool Heights
PixMan Offline
Resident Pariah
******
Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA
#6
09-20-2016, 06:35 AM
(09-20-2016, 05:07 AM)Mike E. Wrote: So, if I understand correctly, Aloris and Dorian tool blocks are interchangeable with each others tool post's ?

Yes. Some of the aftermarket ones may fit tighter on one or the other, though the "factory made" original ones are pretty good for swapping.
Reply
Thanks given by: Mike E.


Messages In This Thread
Resetting Tool Heights - by the penguin - 09-04-2016, 02:17 PM
RE: Resetting Tool Heights - by ieezitin - 09-05-2016, 07:57 AM
RE: Resetting Tool Heights - by PixMan - 09-05-2016, 03:52 PM
RE: Resetting Tool Heights - by the penguin - 09-19-2016, 08:24 PM
RE: Resetting Tool Heights - by Mike E. - 09-20-2016, 05:07 AM
RE: Resetting Tool Heights - by PixMan - 09-20-2016, 06:35 AM



Users browsing this thread: 1 Guest(s)