Latest Delivery

[Vinny]

(09-16-2016, 12:00 PM)the penguin Wrote: Vinny,

Do you have any idea about the fluid flow rate?

I've never used any kind of fluid, I just use compressed air. I have a couple of the Cedarberg magnetic bases and flex-hose and a small air regulator, just enough flow to move the chips out of the way. I set up a couple of small cardboard screens to deflect the chips to one area for easy clean up.

here is a picture of my set up

At 100 PSI with the spray as hard as I can get it (read: fog), it's about 180-200 cc / min. +\- 10cc. My method wasn't' very scientific. It took 33 secs to get to a certain mark on the bottle of water I was using and it took ~100cc to fill it back to the starting mark.

I wanted to get more accuracy but the filter on the end of the feed tube is the same size as my 10cc graduated cylinder (knew I shoulda bought a bigger one).