MetalworkingFun Forum › Machining › General Metalworking Discussion v
Broken tiny tap in aluminium

Thread Modes
Broken tiny tap in aluminium
Highpower Offline
JAFO
******
Posts: 4,452
Threads: 184
Joined: Feb 2012
Location: Missouri, USA
#23
09-15-2016, 10:29 PM
Yeah, I bought a boat load of miniature end mills, drills, and burrs from ebay a couple years ago too. These dental burrs are smaller than even those. I go back every 6 months for a cleaning and another packet of burrs. Smile
Willie
Reply
Thanks given by:


Messages In This Thread
Broken tiny tap in aluminium - by Wongster - 09-07-2016, 11:00 AM
RE: Broken tiny tap in aluminium - by NormanV - 09-07-2016, 12:28 PM
RE: Broken tiny tap in aluminium - by Dr Stan - 09-07-2016, 02:58 PM
RE: Broken tiny tap in aluminium - by TomG - 09-07-2016, 08:42 PM
RE: Broken tiny tap in aluminium - by Vinny - 09-07-2016, 09:31 PM
RE: Broken tiny tap in aluminium - by Mike E. - 09-08-2016, 04:40 AM
RE: Broken tiny tap in aluminium - by Dr Stan - 09-08-2016, 06:40 PM
RE: Broken tiny tap in aluminium - by Highpower - 09-08-2016, 12:22 PM
RE: Broken tiny tap in aluminium - by flosi - 09-08-2016, 12:51 PM
RE: Broken tiny tap in aluminium - by Vinny - 09-08-2016, 06:49 PM
RE: Broken tiny tap in aluminium - by Dr Stan - 09-08-2016, 09:57 PM
RE: Broken tiny tap in aluminium - by flosi - 09-09-2016, 03:07 PM
RE: Broken tiny tap in aluminium - by oldskoolron - 09-09-2016, 01:47 AM
RE: Broken tiny tap in aluminium - by johnnyc14 - 09-09-2016, 12:15 PM
RE: Broken tiny tap in aluminium - by TomG - 09-09-2016, 04:24 PM
RE: Broken tiny tap in aluminium - by Dr Stan - 09-10-2016, 12:21 PM
RE: Broken tiny tap in aluminium - by flosi - 09-13-2016, 03:16 PM
RE: Broken tiny tap in aluminium - by Wongster - 09-14-2016, 07:04 PM
RE: Broken tiny tap in aluminium - by Highpower - 09-15-2016, 06:05 AM
RE: Broken tiny tap in aluminium - by Highpower - 09-15-2016, 03:54 PM
RE: Broken tiny tap in aluminium - by Vinny - 09-15-2016, 06:28 PM
RE: Broken tiny tap in aluminium - by Highpower - 09-15-2016, 10:29 PM
RE: Broken tiny tap in aluminium - by Vinny - 09-15-2016, 10:39 PM
RE: Broken tiny tap in aluminium - by Highpower - 09-15-2016, 11:16 PM
RE: Broken tiny tap in aluminium - by Vinny - 09-16-2016, 04:15 PM



Users browsing this thread: 1 Guest(s)