Let's See Your Mill

[Mike E.]

Hi Tom, yes, it has an INT30 spindle for horizontal use, an MT2 taper in the vertical head, and separate motors for each. The mill came from a university lab, so its only been subject to light use rather than production work. I have been lucky to find some new old stock tooling lately, and last week I acquired a 4 1/2" machine vice in excelent condition, which I painted to match. My 6" vice would be fine for a Bridgeport, but as you can see, its a bit overkill for this mill's 6" wide table; and when properly mounted would restrict the Y-axis travel by about 3", but at least I have it if needed.