|
How to smooth a 5C Collet bore?
|
06-19-2012, 07:05 PM
Tool post grinder while its mounted would be the best. Should reduce it to zero run out till you remove it. Then it would be the repeatability of the chuck mount. What about an aluminum lap mounted to the tail stock? With very little pressure would it remove the run out or just follow it?
Free advice is worth exactly what you payed for it.
Greg |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
How to smooth a 5C Collet bore? - by lazylathe - 06-19-2012, 06:56 PM
RE: How to smooth a 5C Collet bore? - by f350ca - 06-19-2012, 07:05 PM
RE: How to smooth a 5C Collet bore? - by Sunset Machine - 06-19-2012, 08:15 PM
RE: How to smooth a 5C Collet bore? - by PixMan - 06-19-2012, 09:46 PM
RE: How to smooth a 5C Collet bore? - by Sunset Machine - 06-20-2012, 08:01 PM
RE: How to smooth a 5C Collet bore? - by PixMan - 06-21-2012, 05:59 AM
RE: How to smooth a 5C Collet bore? - by TomG - 06-21-2012, 07:06 AM
RE: How to smooth a 5C Collet bore? - by krv3000 - 06-21-2012, 05:56 PM
|
