MetalworkingFun Forum › Machining › How-To's v
How to Indicate A Vise in Just One pass

Thread Modes
How to Indicate A Vise in Just One pass
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#8
06-19-2012, 05:04 PM
(06-19-2012, 04:12 PM)EdAK Wrote: Such a simple concept. Definitely going to try that out.

Well done. Thumbsup

Ed

Thanks Ed.

Simple concepts are about all I can handle. Blink

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
How to Indicate A Vise in Just One pass - by TomG - 06-19-2012, 12:30 PM
RE: How to Indicate A Vise in Just One pass - by TomG - 06-19-2012, 05:04 PM
RE: How to Indicate A Vise in Just One pass - by Wawoodman - 09-08-2012, 11:26 AM
RE: How to Indicate A Vise in Just One pass - by Wawoodman - 09-08-2012, 09:12 PM



Users browsing this thread: 5 Guest(s)