MetalworkingFun Forum › Machining › General Metalworking Discussion v
mmm im stuck

Thread Modes
mmm im stuck
oldskoolron Offline
Sophmore
***
Posts: 106
Threads: 23
Joined: Aug 2016
Location: in the bush qld australia
#18
08-27-2016, 05:22 PM
cheers Anthony but already done the paper thingy to get the slot I needed to get full throttle on a 43 mikuni ..I think from what you've all said ill be stuck doing the cutting with my die grinder with a cutting wheel then smooth it out cheers for all the input again fellas
Reply
Thanks given by:


Messages In This Thread
mmm im stuck - by oldskoolron - 08-17-2016, 05:53 AM
RE: mmm im stuck - by awemawson - 08-17-2016, 09:09 AM
RE: mmm im stuck - by Dr Stan - 08-17-2016, 01:51 PM
RE: mmm im stuck - by oldskoolron - 08-17-2016, 06:51 PM
RE: mmm im stuck - by Dr Stan - 08-17-2016, 07:39 PM
RE: mmm im stuck - by Mayhem - 08-17-2016, 08:00 PM
RE: mmm im stuck - by PixMan - 08-17-2016, 08:25 PM
RE: mmm im stuck - by f350ca - 08-17-2016, 10:21 PM
RE: mmm im stuck - by Vinny - 08-17-2016, 10:30 PM
RE: mmm im stuck - by awemawson - 08-18-2016, 02:00 AM
RE: mmm im stuck - by Sunset Machine - 08-18-2016, 10:59 AM
RE: mmm im stuck - by TomG - 08-18-2016, 03:57 PM
RE: mmm im stuck - by oldskoolron - 08-19-2016, 05:11 AM
RE: mmm im stuck - by pepi - 08-19-2016, 07:34 AM
RE: mmm im stuck - by oldskoolron - 08-26-2016, 09:37 PM
RE: mmm im stuck - by Roadracer_Al - 08-26-2016, 11:25 PM
RE: mmm im stuck - by ieezitin - 08-27-2016, 07:14 AM
RE: mmm im stuck - by oldskoolron - 08-27-2016, 05:22 PM
RE: mmm im stuck - by oldskoolron - 09-25-2016, 04:31 AM



Users browsing this thread: 2 Guest(s)