08-27-2016, 05:14 PM
thanx for the replies fellas .the only time I found it hard is when lil slithers of brass get caught in the dial grooves ect normally I use a paint brush or spend time taking it apart to get the bits which is hard when I am only good for 15 to 30 mins standing at one time .also getting the bits out from the t nut slots on the milling table is a pain .mainly asked to clear it up for those like me that aren't trained or have had the experience ..plus its even harder when using oils or wd40 as it tends to clump to the machine in use .that why ive decided to use a mix of soluble oil an water .it cools the job adds some lube but is also able to evaporate in the heat of the day here 27c to 35c