mmm im stuck

[oldskoolron]

thanks all for the feedback ..im gunna give it a shot saturadayall going good .so many new words an so many parts connected to lathes n mills but im learning .reason I want reasonably quik is I have 3 blown dics in lower back an standing is agony after 15 to 30 mins I got stool setup at mill but hving the lathe at waist height mite not be safe on a chair for me ect .think ill firstly do as mentioned .put long [24inch] bit of 1inch bar in lthe and work through the different thread settings to see if any go close .if that not a goer I think the old hacksaw or drill may be the way to go .I want to make a few sets for Harleys an other jap and brit bikes as ive had few mates ect ask about it also ive had them ask about the hydraulic clutch setup id like to make .ill post [if I remember to take them] some picts of my exploring lol
once again thanx for the help [I need it]