|
mmm im stuck
|
08-18-2016, 03:57 PM
Without all the fancy set-ups and equipment, just calculate the lead of the helix in thousandths per degree, mount the part in a dividing head and step mill the slot by rotating the dividing head and stepping the end mill over the required amount. Obviously the more steps you take, the better the slot will look.
Tom ![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png) |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
mmm im stuck - by oldskoolron - 08-17-2016, 05:53 AM
RE: mmm im stuck - by awemawson - 08-17-2016, 09:09 AM
RE: mmm im stuck - by Dr Stan - 08-17-2016, 01:51 PM
RE: mmm im stuck - by oldskoolron - 08-17-2016, 06:51 PM
RE: mmm im stuck - by Dr Stan - 08-17-2016, 07:39 PM
RE: mmm im stuck - by Mayhem - 08-17-2016, 08:00 PM
RE: mmm im stuck - by PixMan - 08-17-2016, 08:25 PM
RE: mmm im stuck - by f350ca - 08-17-2016, 10:21 PM
RE: mmm im stuck - by Vinny - 08-17-2016, 10:30 PM
RE: mmm im stuck - by awemawson - 08-18-2016, 02:00 AM
RE: mmm im stuck - by Sunset Machine - 08-18-2016, 10:59 AM
RE: mmm im stuck - by TomG - 08-18-2016, 03:57 PM
RE: mmm im stuck - by oldskoolron - 08-19-2016, 05:11 AM
RE: mmm im stuck - by pepi - 08-19-2016, 07:34 AM
RE: mmm im stuck - by oldskoolron - 08-26-2016, 09:37 PM
RE: mmm im stuck - by Roadracer_Al - 08-26-2016, 11:25 PM
RE: mmm im stuck - by ieezitin - 08-27-2016, 07:14 AM
RE: mmm im stuck - by oldskoolron - 08-27-2016, 05:22 PM
RE: mmm im stuck - by oldskoolron - 09-25-2016, 04:31 AM
|
