MetalworkingFun Forum › Machining › General Metalworking Discussion v
mmm im stuck

Thread Modes
mmm im stuck
PixMan Offline
Resident Pariah
******
Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA
#7
08-17-2016, 08:25 PM
Wish I had even the third axis (under CNC control) on my mill. 2 axis with manual Z is what they call it. :(

Another option might be a ball mill, hold it in the vise, swivel vise to 45º and cut. Rotate part a little, cut again.
Reply
Thanks given by:


Messages In This Thread
mmm im stuck - by oldskoolron - 08-17-2016, 05:53 AM
RE: mmm im stuck - by awemawson - 08-17-2016, 09:09 AM
RE: mmm im stuck - by Dr Stan - 08-17-2016, 01:51 PM
RE: mmm im stuck - by oldskoolron - 08-17-2016, 06:51 PM
RE: mmm im stuck - by Dr Stan - 08-17-2016, 07:39 PM
RE: mmm im stuck - by Mayhem - 08-17-2016, 08:00 PM
RE: mmm im stuck - by PixMan - 08-17-2016, 08:25 PM
RE: mmm im stuck - by f350ca - 08-17-2016, 10:21 PM
RE: mmm im stuck - by Vinny - 08-17-2016, 10:30 PM
RE: mmm im stuck - by awemawson - 08-18-2016, 02:00 AM
RE: mmm im stuck - by Sunset Machine - 08-18-2016, 10:59 AM
RE: mmm im stuck - by TomG - 08-18-2016, 03:57 PM
RE: mmm im stuck - by oldskoolron - 08-19-2016, 05:11 AM
RE: mmm im stuck - by pepi - 08-19-2016, 07:34 AM
RE: mmm im stuck - by oldskoolron - 08-26-2016, 09:37 PM
RE: mmm im stuck - by Roadracer_Al - 08-26-2016, 11:25 PM
RE: mmm im stuck - by ieezitin - 08-27-2016, 07:14 AM
RE: mmm im stuck - by oldskoolron - 08-27-2016, 05:22 PM
RE: mmm im stuck - by oldskoolron - 09-25-2016, 04:31 AM



Users browsing this thread: 4 Guest(s)