Making Dickson QCTP holders
#6
(08-03-2016, 11:49 PM)Rickabilly Wrote: Sorry Dave, I didn't realise this had been done before, thanks for letting me know though Darren, I can now assume folks know a little more about these great little tool holders, well... mine aren't so little... as this particular set are for my Colchester Mascot so are about 125mm Long and can hole 1" square shanked tooling.

regards
Rick

Mine will accept 1 1/4" shank tools Big Grin
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Making Dickson QCTP holders - by Rickabilly - 07-29-2016, 02:36 AM
RE: Making Dickson QCTP holders - by Mayhem - 07-29-2016, 05:43 AM
RE: Making Dickson QCTP holders - by Rickabilly - 08-03-2016, 11:49 PM
RE: Making Dickson QCTP holders - by Rickabilly - 08-04-2016, 12:59 AM
RE: Making Dickson QCTP holders - by awemawson - 08-04-2016, 02:54 AM
RE: Making Dickson QCTP holders - by Mayhem - 08-04-2016, 06:27 AM
RE: Making Dickson QCTP holders - by Rickabilly - 08-04-2016, 07:07 PM
RE: Making Dickson QCTP holders - by krv3000 - 08-04-2016, 02:52 PM
RE: Making Dickson QCTP holders - by Mayhem - 08-04-2016, 07:22 PM
RE: Making Dickson QCTP holders - by Mayhem - 09-04-2016, 07:35 PM



Users browsing this thread: 7 Guest(s)