Making Dickson QCTP holders
#5
As you say that particular style of Dickson tool post with the off set feature was the one intended for hydraulic copy turning and was supplied standard with the Hepworth tracing accessory.

I made loads of Dickson 'T2' holders out of EN8 years back when I still had a horizontal mill, and I must say it's use made things much easier. You can't have too many holders :)
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:


Messages In This Thread
Making Dickson QCTP holders - by Rickabilly - 07-29-2016, 02:36 AM
RE: Making Dickson QCTP holders - by Mayhem - 07-29-2016, 05:43 AM
RE: Making Dickson QCTP holders - by Rickabilly - 08-03-2016, 11:49 PM
RE: Making Dickson QCTP holders - by Rickabilly - 08-04-2016, 12:59 AM
RE: Making Dickson QCTP holders - by awemawson - 08-04-2016, 02:54 AM
RE: Making Dickson QCTP holders - by Mayhem - 08-04-2016, 06:27 AM
RE: Making Dickson QCTP holders - by Rickabilly - 08-04-2016, 07:07 PM
RE: Making Dickson QCTP holders - by krv3000 - 08-04-2016, 02:52 PM
RE: Making Dickson QCTP holders - by Mayhem - 08-04-2016, 07:22 PM
RE: Making Dickson QCTP holders - by Mayhem - 09-04-2016, 07:35 PM



Users browsing this thread: 3 Guest(s)