08-04-2016, 01:45 AM
(This post was last modified: 08-04-2016, 01:47 AM by Rickabilly.
Edit Reason: grammar/spelling corrections
)
Having made more than a couple of these Dixon holders now, I can assure y'all the important dimensions in order are;
1, Vee groove centres
2, depth of the Tee slot clamping face
3, finally the centralisation of the main square groove that forms the tee slot as there is a key block on some toolposts.
Grinding all the faces would be ideal but a nice milled finish is just as good for 99% of uses, given that keeping everything clean in use if far more important for accuracy in use,
Regards
Rick
1, Vee groove centres
2, depth of the Tee slot clamping face
3, finally the centralisation of the main square groove that forms the tee slot as there is a key block on some toolposts.
Grinding all the faces would be ideal but a nice milled finish is just as good for 99% of uses, given that keeping everything clean in use if far more important for accuracy in use,
Regards
Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.