Making Dickson QCTP holders
#3
Sorry Dave, I didn't realise this had been done before, thanks for letting me know though Darren, I can now assume folks know a little more about these great little tool holders, well... mine aren't so little... as this particular set are for my Colchester Mascot so are about 125mm Long and can hole 1" square shanked tooling.

regards
Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.
Reply
Thanks given by:


Messages In This Thread
Making Dickson QCTP holders - by Rickabilly - 07-29-2016, 02:36 AM
RE: Making Dickson QCTP holders - by Mayhem - 07-29-2016, 05:43 AM
RE: Making Dickson QCTP holders - by Rickabilly - 08-03-2016, 11:49 PM
RE: Making Dickson QCTP holders - by Rickabilly - 08-04-2016, 12:59 AM
RE: Making Dickson QCTP holders - by awemawson - 08-04-2016, 02:54 AM
RE: Making Dickson QCTP holders - by Mayhem - 08-04-2016, 06:27 AM
RE: Making Dickson QCTP holders - by Rickabilly - 08-04-2016, 07:07 PM
RE: Making Dickson QCTP holders - by krv3000 - 08-04-2016, 02:52 PM
RE: Making Dickson QCTP holders - by Mayhem - 08-04-2016, 07:22 PM
RE: Making Dickson QCTP holders - by Mayhem - 09-04-2016, 07:35 PM



Users browsing this thread: 6 Guest(s)