MetalworkingFun Forum › Machining › General Metalworking Discussion v
So this is how it happens...

Thread Modes
So this is how it happens...
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#3
07-11-2016, 01:25 PM
One needs to remember these companies are run by sales personnel and usually have little to no background in machining/metal working.  So putting a shaper vice on a mill would be OK in their world since its just a vice right? Bash
Reply
Thanks given by:


Messages In This Thread
So this is how it happens... - by Pete O - 07-11-2016, 08:18 AM
RE: So this is how it happens... - by f350ca - 07-11-2016, 01:02 PM
RE: So this is how it happens... - by Dr Stan - 07-11-2016, 01:25 PM
RE: So this is how it happens... - by Pete O - 07-12-2016, 02:49 AM
RE: So this is how it happens... - by PixMan - 07-12-2016, 07:10 AM
RE: So this is how it happens... - by Rickabilly - 07-13-2016, 12:30 PM
RE: So this is how it happens... - by Pete O - 07-15-2016, 10:55 AM



Users browsing this thread: 3 Guest(s)