MetalworkingFun Forum › Machining › Welding & Casting v
[HELP] Learning Tig Welding

Thread Modes
Help Learning Tig Welding
aametalmaster Offline
MTLMSTR
****
Posts: 410
Threads: 77
Joined: Mar 2012
Location: Salem, Ohio
#14
07-09-2016, 11:35 AM
Some of the info that the members is good but the first post was by a spammer. I have seen the exact post on a few other forums. Just my .02. And I used to make close to 100 grand a year TIG welding but those days are gone...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
Learning Tig Welding - by Harryw - 06-09-2016, 12:07 AM
RE: Learning Tig Welding - by pepi - 06-09-2016, 06:41 AM
RE: Learning Tig Welding - by f350ca - 06-09-2016, 08:07 AM
RE: Learning Tig Welding - by Dr Stan - 06-09-2016, 09:14 AM
RE: Learning Tig Welding - by Roadracer_Al - 06-09-2016, 03:23 PM
RE: Learning Tig Welding - by TomG - 06-09-2016, 07:10 PM
RE: Learning Tig Welding - by Roadracer_Al - 06-09-2016, 08:26 PM
RE: Learning Tig Welding - by Harryw - 06-10-2016, 04:09 AM
RE: Learning Tig Welding - by rleete - 06-10-2016, 08:34 AM
RE: Learning Tig Welding - by ieezitin - 06-11-2016, 10:11 AM
RE: Learning Tig Welding - by Dr Stan - 06-11-2016, 11:21 AM
RE: Learning Tig Welding - by Roadracer_Al - 06-11-2016, 01:41 PM
RE: Learning Tig Welding - by Dr Stan - 06-11-2016, 03:43 PM
RE: Learning Tig Welding - by aametalmaster - 07-09-2016, 11:35 AM
RE: Learning Tig Welding - by Dr Stan - 07-09-2016, 05:53 PM
RE: Learning Tig Welding - by Mayhem - 07-09-2016, 07:24 PM
RE: Learning Tig Welding - by aametalmaster - 07-09-2016, 08:50 PM
RE: Learning Tig Welding - by Mayhem - 07-09-2016, 08:57 PM



Users browsing this thread: 4 Guest(s)