As many of you know, I picked up a Kondia FV-1 mill a few months back. Now whilst I haven't done a lot to it due to time constraints, I plan on removing the table to check the screw and nut (to see if it can be adjusted), as well as clean the oil lines.
I will make a couple of plates to bolt to each end of the table and plan to lift it off with an engine hoist. I have seen people say to use t-nuts in the slots to lift it but I'm not convinced.
What are the steps involved here, or how would you suggest I proceed? All suggestions welcome.
I will make a couple of plates to bolt to each end of the table and plan to lift it off with an engine hoist. I have seen people say to use t-nuts in the slots to lift it but I'm not convinced.
What are the steps involved here, or how would you suggest I proceed? All suggestions welcome.
Hunting American dentists since 2015.