MetalworkingFun Forum › Machining › General Metalworking Discussion v
D1-3 Camlock Backplate Fix

Thread Modes
D1-3 Camlock Backplate Fix
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#2
06-19-2012, 06:55 AM (This post was last modified: 06-19-2012, 06:56 AM by stevec.)
Good job John, more patience than I have ever exhibited. Where did you get that snazzy "tapping device" you used to fine adjust the compound?Smile I think I have a few just like it.Blush
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
D1-3 Camlock Backplate Fix - by JohnC - 06-19-2012, 06:42 AM
RE: D1-3 Camlock Backplate Fix - by stevec - 06-19-2012, 06:55 AM
RE: D1-3 Camlock Backplate Fix - by Highpower - 06-19-2012, 10:04 AM
RE: D1-3 Camlock Backplate Fix - by krv3000 - 06-19-2012, 05:00 PM
RE: D1-3 Camlock Backplate Fix - by EdK - 06-19-2012, 05:46 PM
RE: D1-3 Camlock Backplate Fix - by DaveH - 06-19-2012, 06:53 PM
RE: D1-3 Camlock Backplate Fix - by Mayhem - 06-20-2012, 05:23 AM
RE: D1-3 Camlock Backplate Fix - by f350ca - 03-25-2013, 09:35 PM
RE: D1-3 Camlock Backplate Fix - by Micktoon - 03-26-2013, 05:26 PM
RE: D1-3 Camlock Backplate Fix - by ronboult - 05-29-2014, 10:38 PM
RE: D1-3 Camlock Backplate Fix - by Hopefuldave - 05-30-2014, 04:33 AM



Users browsing this thread: 2 Guest(s)