MetalworkingFun Forum › Machining › Gunsmithing v
Cheap Ammo Cans

Thread Modes
Cheap Ammo Cans
Roadracer_Al Offline
Junior
****
Posts: 691
Threads: 14
Joined: Feb 2015
Location: Oakland, California
The following 1 user Likes Roadracer_Al's post:
Highpower (06-22-2016)
#4
06-21-2016, 11:54 PM
The use I've seen which I like a lot is for holding quenching oil for hardening steel. This is commonly done by knifemakers. I like that you can flip the lid down if the oil flares up, and if the seal is in good condition, it prevents spills when the lid is latched down.
Reply
Thanks given by:


Messages In This Thread
Cheap Ammo Cans - by EdK - 06-19-2016, 09:15 AM
RE: Cheap Ammo Cans - by Vinny - 06-19-2016, 10:02 PM
RE: Cheap Ammo Cans - by Highpower - 06-20-2016, 01:42 PM
RE: Cheap Ammo Cans - by Roadracer_Al - 06-21-2016, 11:54 PM
RE: Cheap Ammo Cans - by rleete - 06-22-2016, 08:59 AM
RE: Cheap Ammo Cans - by arvidj - 06-27-2016, 10:40 AM
RE: Cheap Ammo Cans - by Highpower - 06-27-2016, 09:47 PM
RE: Cheap Ammo Cans - by f350ca - 06-27-2016, 12:13 PM
RE: Cheap Ammo Cans - by arvidj - 06-27-2016, 06:15 PM
RE: Cheap Ammo Cans - by f350ca - 06-27-2016, 08:04 PM



Users browsing this thread: 1 Guest(s)