06-18-2012, 03:15 PM
Hi Guys!
I finally finished my first project!
A PM Research 2A wobbler.
Not too bad for a first project and it only took me a week to do it!
I did not take any during pictures...
It is simple and enough have been built!
I still need to disassemble it and paint it but that will be done when time permits.
The good news it... IT RUNS!!!!!
Anyway here is a very short clip taken with my iphone.
Once it is complete i will do a better one!
http://youtu.be/ShCiVHDcxD0
Andrew
I finally finished my first project!
A PM Research 2A wobbler.
Not too bad for a first project and it only took me a week to do it!
I did not take any during pictures...
It is simple and enough have been built!
I still need to disassemble it and paint it but that will be done when time permits.
The good news it... IT RUNS!!!!!
Anyway here is a very short clip taken with my iphone.
Once it is complete i will do a better one!
http://youtu.be/ShCiVHDcxD0
Andrew
A proud member of MetalworkingFun Forum since Feb 2012.
1959 Myford ML7,1949 South Bend 9A,Clausing 8520 mill,Keller Die filer,1929 Rhodes Shaper.
1959 Myford ML7,1949 South Bend 9A,Clausing 8520 mill,Keller Die filer,1929 Rhodes Shaper.