Setting Up My PM935 Mill

[EdK]

(06-08-2016, 03:54 AM)Dave J Wrote: Really nice work Ed, and the rewards will be for many years to come. 
As you know I haven't been around on any forums for a while, and the last I read your mill you where getting it into the basement. What a suprise i got when i read today what you have done since,

I remember going through my mill, but went over board cleaning and filling all the inside of every casting other than the column as it was pretty good like yours.still gives me pleasure looking at it and is easy cleaning but a lot of work went into it.

Congratulations on not only getting a great mill but going the extra yard giving it a going over and accessorising it.

Dave J

Thanks Dave. It's good to see you back in action. I've missed you. You always had really good posts.

Ed