|
Sieg C2 Milling attachment
|
05-29-2016, 07:10 PM
I had one, looked heavier though that I used on a 14x40 lathe. Its not a replacement for a proper milling machine but better than a file and chisel. I cut a lot of keyways with it using the 3 jaw to hold the end mill, apparently that doesn't work, but I didn't know that at the time.
Free advice is worth exactly what you payed for it.
Greg |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Sieg C2 Milling attachment - by panama - 05-20-2016, 10:14 PM
RE: Sieg C2 Milling attachment - by Vinny - 05-21-2016, 12:50 AM
RE: Sieg C2 Milling attachment - by panama - 05-28-2016, 08:55 AM
RE: Sieg C2 Milling attachment - by TomG - 05-28-2016, 10:10 AM
RE: Sieg C2 Milling attachment - by Dr Stan - 05-28-2016, 11:50 PM
RE: Sieg C2 Milling attachment - by f350ca - 05-29-2016, 07:10 PM
RE: Sieg C2 Milling attachment - by Dr Stan - 05-31-2016, 12:22 AM
RE: Sieg C2 Milling attachment - by panama - 06-26-2016, 09:07 AM
|
