|
Degree Finder or DRO Question
|
06-18-2012, 07:38 AM
Some radial arm saws had digital read outs and the circular one would do for a drill press and round column mill installation. I don't think they're fine enough resolution though.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Degree Finder or DRO Question - by November X-ray - 06-17-2012, 05:40 PM
RE: Degree Finder or DRO Question - by ScrapMetal - 06-17-2012, 08:08 PM
RE: Degree Finder or DRO Question - by DaveH - 06-17-2012, 08:20 PM
RE: Degree Finder or DRO Question - by ETC57 - 06-17-2012, 08:50 PM
RE: Degree Finder or DRO Question - by f350ca - 06-17-2012, 11:22 PM
RE: Degree Finder or DRO Question - by November X-ray - 06-18-2012, 05:25 AM
RE: Degree Finder or DRO Question - by stevec - 06-18-2012, 07:38 AM
RE: Degree Finder or DRO Question - by November X-ray - 06-18-2012, 08:00 AM
RE: Degree Finder or DRO Question - by EdK - 06-18-2012, 10:33 AM
RE: Degree Finder or DRO Question - by Highpower - 06-18-2012, 02:02 PM
RE: Degree Finder or DRO Question - by ScrapMetal - 06-18-2012, 02:17 PM
RE: Degree Finder or DRO Question - by Highpower - 06-18-2012, 03:14 PM
RE: Degree Finder or DRO Question - by November X-ray - 06-18-2012, 04:49 PM
RE: Degree Finder or DRO Question - by doubleboost - 06-18-2012, 06:00 PM
RE: Degree Finder or DRO Question - by stevec - 06-19-2012, 06:45 AM
RE: Degree Finder or DRO Question - by ScrapMetal - 06-19-2012, 01:51 PM
|
