MetalworkingFun Forum › Machining › General Metalworking Discussion v
What to use...

Thread Modes
What to use...
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#2
05-11-2016, 05:53 AM
Depends on your definition of a problem:

Is there a risk that it will rust - Yes, if you don't coat it.
Is there a risk it won't be strong enough - I don't think you have anything to worry about there but I'll leave the engineers to comment with authority Big Grin
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
What to use... - by Vinny - 05-10-2016, 10:44 PM
RE: What to use... - by Mayhem - 05-11-2016, 05:53 AM
RE: What to use... - by Dr Stan - 05-11-2016, 11:18 AM
RE: What to use... - by Vinny - 05-11-2016, 06:37 PM
RE: What to use... - by EdK - 05-11-2016, 08:29 PM
RE: What to use... - by Rob.Mueller - 05-12-2016, 07:53 PM
RE: What to use... - by PixMan - 05-12-2016, 06:42 AM
RE: What to use... - by Vinny - 05-12-2016, 08:05 PM



Users browsing this thread: 1 Guest(s)