05-03-2016, 10:16 PM
Decided to go with a contactor for the on off so needed to make an enclosure for the relay and 24 volt transformer. The plasma does an incredible job of cutting sheet metal. With a 40 amp nozzle it cuts slower thus giving sharper corners. Used an old shelf from a office cabinet.
![[Image: IMG_2170.jpg]](https://lh3.googleusercontent.com/-h89pEkHlqi0/VylmNvyxpvI/AAAAAAAAD0U/2CzYrBV0jCILknXvLwLqbiH3oOjFECsWACCo/s1280/IMG_2170.jpg)
Ran conduit over for the 220 supply, wasn't sure on the electrical code, think you need a disconnect switch if its more than a few feet from the service panel so I added a plug in. Finished the plumbing and its good to go.
![[Image: IMG_2172.jpg]](https://lh3.googleusercontent.com/-ydOdJ0o8wd0/VylmN_GYLUI/AAAAAAAAD0Y/90qJmkuJJzk5nOKAILh8EN1idXohE2AmACCo/s1280/IMG_2172.jpg)
Works like a charm, fairly quiet. Still need some sort of cage or shelf to hold a detergent bottle.
Thanks for watching.
Ran conduit over for the 220 supply, wasn't sure on the electrical code, think you need a disconnect switch if its more than a few feet from the service panel so I added a plug in. Finished the plumbing and its good to go.
Works like a charm, fairly quiet. Still need some sort of cage or shelf to hold a detergent bottle.
Thanks for watching.
Free advice is worth exactly what you payed for it.
Greg
Greg