05-03-2016, 11:46 AM
The next part to receive attention is the cam shaft so I parted of to length 4 pieces of stainless and centred the ends.
Then up between centres to rough down to size using my favourite tool .
Then clean up the edges.
And start setting up the mill to form the cam.
I may try to video this opp we will see how it goes.
Brian.
Then up between centres to rough down to size using my favourite tool .
Then clean up the edges.
And start setting up the mill to form the cam.
I may try to video this opp we will see how it goes.
Brian.
