06-17-2012, 08:08 PM
You could do that easy enough. I just don't think there would be enough call for it to make it commercially viable as I think most drill press operations are considered "close enough".
Now, for the guys who tend towards OCD (myself included
) might consider something like this centering scope:
![[Image: 0653933-11.jpg]](http://www.use-enco.com/ProductImages/0653933-11.jpg)
Enco - Centering Scope
Put it in the chuck and you can line it back up to your mark in no time.
Personally, I may need to get one but lots of other tools I need to get first.
-Ron
Now, for the guys who tend towards OCD (myself included
) might consider something like this centering scope:Enco - Centering Scope
Put it in the chuck and you can line it back up to your mark in no time.
Personally, I may need to get one but lots of other tools I need to get first.
-Ron
11" South Bend lathe - Wells-Index 860C mill - 16" Queen City Shaper