04-30-2016, 11:00 PM
That was plan A, Al, or maybe plan A-1, A-1 was developed when I realized they were going to hit each other. Didn't think it would look right tilted and was concerned about the oil level.
The screws that go through the motor would only have been threaded into the aluminum about 1/4 inch, they're better in the steel studs anyway.
Got the pump mounted to the wall and some of the water line ran. Need to get to town for conduit to run a 220 circuit over there and some more fittings.
![[Image: IMG_2167.jpg]](https://lh3.googleusercontent.com/-gBIyP24AH5E/VyUyXikvqdI/AAAAAAAADzo/0cG1QbjcmYwhmk6cUU7VF1X6Ar6vcjIpwCCo/s1280/IMG_2167.jpg)
The screws that go through the motor would only have been threaded into the aluminum about 1/4 inch, they're better in the steel studs anyway.
Got the pump mounted to the wall and some of the water line ran. Need to get to town for conduit to run a 220 circuit over there and some more fittings.
Free advice is worth exactly what you payed for it.
Greg
Greg