MetalworkingFun Forum › Machining › General Metalworking Discussion v
new machinist forum

Thread Modes
new machinist forum
chucketn Offline
Junior
****
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
#3
04-27-2016, 05:04 PM
Looks like it's oriented toward professional machinists.

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
new machinist forum - by Dr Stan - 04-27-2016, 01:09 PM
RE: new machinist forum - by awemawson - 04-27-2016, 02:48 PM
RE: new machinist forum - by chucketn - 04-27-2016, 05:04 PM
RE: new machinist forum - by PixMan - 04-27-2016, 07:17 PM
RE: new machinist forum - by Vinny - 04-27-2016, 07:19 PM
RE: new machinist forum - by Dr Stan - 04-27-2016, 08:04 PM
RE: new machinist forum - by TomG - 04-27-2016, 08:06 PM
RE: new machinist forum - by Dr Stan - 04-28-2016, 07:35 AM
RE: new machinist forum - by awemawson - 04-28-2016, 02:48 AM
RE: new machinist forum - by chucketn - 04-28-2016, 05:24 AM
RE: new machinist forum - by Mayhem - 04-28-2016, 06:43 AM
RE: new machinist forum - by Highpower - 04-28-2016, 08:46 AM
RE: new machinist forum - by the penguin - 04-28-2016, 09:40 AM
RE: new machinist forum - by Dr Stan - 04-28-2016, 12:43 PM
RE: new machinist forum - by EdK - 04-28-2016, 05:56 PM
RE: new machinist forum - by Roadracer_Al - 04-28-2016, 08:00 PM
RE: new machinist forum - by Dr Stan - 04-28-2016, 11:12 PM
RE: new machinist forum - by Dr Stan - 07-31-2016, 06:55 PM
RE: new machinist forum - by pepi - 07-31-2016, 09:36 PM
RE: new machinist forum - by Highpower - 08-01-2016, 03:01 PM
RE: new machinist forum - by PixMan - 08-01-2016, 08:54 PM
RE: new machinist forum - by Highpower - 08-02-2016, 04:54 PM



Users browsing this thread: 3 Guest(s)