04-24-2016, 06:08 AM
(04-23-2016, 09:55 PM)EdK Wrote:(04-23-2016, 09:45 PM)f350ca Wrote: Welcome Michael,
I'd be surprised if the nut was a press fit, there would be no way to align it as it was pressed in. The drawing shows a 3/8 set screw coming in from the front, would that be holding it by going into the recess.
+1. That was my thought also.
Ed
Keen eye! That makes sense given the configuration of the part. The front of the slide is so caked with grease I didn't see the set screw hole. I'll give it a closer look.
Thanks for your help,
Michael