Clausing Mill - 8530
#5
(04-23-2016, 09:45 PM)f350ca Wrote: Welcome Michael,
I'd be surprised if the nut was a press fit, there would be no way to align it as it was pressed in. The drawing shows a 3/8 set screw coming in from the front, would that be holding it by going into the recess.

+1. That was my thought also.

Ed
Reply
Thanks given by:


Messages In This Thread
Clausing Mill - 8530 - by mirain33 - 04-23-2016, 05:07 PM
RE: Clausing Mill - 8530 - by Mayhem - 04-23-2016, 08:16 PM
RE: Clausing Mill - 8530 - by mirain33 - 04-23-2016, 09:26 PM
RE: Clausing Mill - 8530 - by f350ca - 04-23-2016, 09:45 PM
RE: Clausing Mill - 8530 - by EdK - 04-23-2016, 09:55 PM
RE: Clausing Mill - 8530 - by mirain33 - 04-24-2016, 06:08 AM
RE: Clausing Mill - 8530 - by Mayhem - 04-24-2016, 12:36 AM



Users browsing this thread: 1 Guest(s)